Maintenance of soldering iron

0 comments

The cleaning sponge should be used to clean the soldering iron tip regularly.

After soldering, the oxides and carbides produced by the residual flux of the iron tip will damage the soldering iron tip, cause welding errors, or reduce the thermal function of the soldering iron tip. Long-term continuous use At the same time, the soldering iron tip should be disassembled once a week to remove oxides to prevent the damaged surface of the soldering iron tip from reducing the temperature.


The temperature of the soldering iron tip is too high or the function of the soldering iron tip is reduced. Therefore, the temperature should be selected as low as possible. When the temperature of the soldering iron tip is normal, it can protect the temperature-sensitive components;
When the soldering iron is not in use, do not leave the soldering iron in a high temperature state for a long time, which will convert the agent on the soldering iron tip into oxides and reduce the function of the soldering iron tip;
After use, the soldering iron tip should be cleaned and plated with a new tin layer to prevent oxidation of the soldering iron tip;


The temperature of the soldering iron tip should not be too high and should be within the set range.
Sponge should be used to clean the soldering iron tip regularly and the soldering iron tip should be disassembled once a week to remove oxides, because the residue on the soldering iron tip will damage the soldering iron tip, causing soldering errors and reduced thermal conductivity.


When using a sponge, wet the water first and then squeeze it dry, otherwise it will damage the soldering iron tip.
After using the soldering iron, wipe the tip of the soldering iron clean and add a small amount of new tin layer to prevent oxidation of the soldering iron tip;
When the soldering iron tip is deformed or rusted, or the ground impedance exceeds the specification, a new product must be replaced.
Check and clean the soldering iron head
The set temperature is 370±10℃
After the temperature stabilizes, clean the soldering iron tip with a cleaning sponge and check the condition of the soldering iron tip
If there is black oxide on the tin-plated part of the soldering iron tip, it can be plated with a new tin layer and then wiped clean with a cleaning sponge. Repeat cleaning until the oxide is removed, and then plate a new tin layer
If the soldering iron tip is deformed or unnatural, it must be replaced with a new one

Leave a comment

All blog comments are checked prior to publishing
You have successfully subscribed!
This email has been registered
ico-collapse
0
Recently Viewed
ic-cross-line-top
Top
ic-expand
ic-cross-line-top