SEQURE ODESC 3.6 For 48v electric go kart DIY
Hall sensor wires
Download pyton or anaconda CMD
To start type:odrivetoo and wait to start
connect Sequre ODESC3.6 to your computer and power it up
when hardware number shown it already connected
Config the motor
I am using 6483 motor
After saving the program reboot it to reconnect the
And wait for hardware number
Wait for beep on motor
PWN signal connected in GPI04 for M0, GPI03 for M1 PWM
PWN min and max works better on:600 -300
this is program for M0. to config the M1, replace the odrv0 to odrv1
ex.
odrv0.save_configuration()
change to ...
odrv1.save_configuration()
odrv0.save_configuration()
odrv1.save_configuration()
I only set up 48V 20A on each motor but it can up to 50A and ODESC3.6 also need heatsink
Dear Customer/DIYer
Thank you very much for your support and hope you have a happy and interesting shopping experience. We are very welcome to the majority of customers and friends to participate in our DIY interesting articles sharing activities.
Share & Cash Back
The number of words is more than 300 words, have exquisite picture in the article. Send us your article. After check your article and it pass through, we will cashback the amount of 5-8 dollars according to the quality of the articles.
Welcome to contact this email (info@sequremall.com) and send us the articles for checking.
